Filling capacity: 12ML
Temperature: flame temperature 1300°C, soldering iron temperature 450°C
Material: Plastic
Fuel: Pure Butane
Use time: 50-80 minutes
Size: 200* diameter 20MM
(with supporting feet for easy use)
I. Filling gas
1. Fill up with high-quality gas and confirm that the switch is OFF.
2. Introduce the gas tank into the air hole and inflate it under pressure.
3, about 10 seconds, can fill the gas, wait a few minutes, let the gas stable, and then use it again.
4, if the gas is poured into the tail, when there is a squeaking sound, use a nib to press the gas port slightly to eliminate it.
Second, ignition
1, put the iron head
2. Push the switch to the ON position and hear the sound of "click".
3, use an igniter or lighter, near the joint ignition.
4. Burn for 3 minutes after ignition and wait for the fire to extinguish. The iron head will continue to heat up.
5, adjust the size of the flame, to the "ten" direction is large, to the "one" direction is small.
6, this product temperature up to 1300 degrees (iron temperature 450 degrees), the use of safety should be taken, after the use of the switch closed to the OFF position.
7. When using the gas soldering iron, pay special attention to wait until the flame is completely eliminated. When the object inside the soldering iron turns red, operate it again. The size of the flame should not be large to prolong the service life of the soldering iron.
8, the length of the flame is about 1.2-2.2 cm.
Third, note:
1. Replace the connector. Wait until it cools before replacing it or changing it in advance.
2, the use of iron head, high temperature and hot, do not touch it with your hands.
3. The adjustment button can control the gas output and temperature of the gas, usually placed in the middle position.
4, after use to be cooled, re-collection, do not place in high temperature or direct sunlight.
5, children should not be used, the collection must be properly placed.
6, please use high-quality canned gas filling, fill away from the fire source.
7, because the gas is more or less slag quality, it is necessary to clean the nozzle.
8. When cleaning, spray the nozzle on the air outlet of the gas tank to achieve cleaning effect.
9, avoid falling.
10. Do not try to disassemble or repair under any circumstances.