How to repair, seen the step:
1: Use alcohol with cloth Clean the dent place
2: Glue gun (with glue stick) Plug in the power supply, wait 3-5 minute (if you not have the Glue gun , you can buy in our store)
3: Choose the right black dent tabs , and apply glue full in the tabs ( have 6 size dent tabs to choose , more big dent need use more big dent tabs)
4: Use black dent tabs fixed at dent place
5: Use the pdr pulling bridge Screw holes Align the black tabs, screw the cap onto the tabs and tighten it tight, tighten the screw cap until the small pit is repaired
6: Repair ok later, Twist off the nut , take out the pulling bridge, use the alcohol and rubber scraper clean the glue

Note: If the above repair is not repaired successfully, please repeat the repair again
1: If the surface after repair has raised point, you can use the thumb presses the bump
2: Use the use the thumb presses the bump also not have effect , you can try our store Tap down Pen and Rubber hammer , if you need you can buy in our store , thank you!