Output Current: 20 ~ 400mA (preferably not more than normal 400mA); Dimensions: 1.4cm long * 0. 9cm width * 0.8cm height; Description: This strobe circuit board can be used without modification function of the LED strobe lights, and other LED lighting devices. Burst flash chip with a new generation of high-current control transistor, the maximum safe output current is 400mA, strobe effect, full-chip process design, small size super large-capacity capacitor line filter, high-grade red FR4 PCB. Note: This board without a constant and can not be directly connected to the LED lamp requires limiting series resistors, resistor size by controlling the current size. Strobe Mode: This board is dual-mode burst flash control mode Always one end, the other end strobe mode. If used as brake lights for double wire or double contact, driving is lit (low light), brake when Strobe (highlighted). With a single burst flash mode, strobe terminal directly connected to, the power to start (highlighted) strobe. Strobe frequency: 6 times per second, fast flash off half a second cycle.
Packing List
1 x DIY Strobe Controller
Dimensions: 0.55 in x 0.35 in x 0.31 in (1.4 cm x 0.9 cm x 0.8 cm) Weight: 0.04 oz (1 g)
This website uses cookies for the correct display and functionality. Do you also want to take full advantage of the website and accept cookies? About cookies. Accept cookies
