This flash trigger supports flash grouping and remote flash power control; With sensitive reactions and stable signal transmission, it applies to flashes with the wireless control port, such as, Godox Wistro AD-180 & AD-360, Godox QT series and Gemini GT & GS series studio flashes, as well as specific camera flashes. It is also compatible with Godox Cells series transceiver.
Features:
Power, wireless control flash 16 packets
Remote control lamp and focus lamp, and a buzzer switch
Wireless synchronous flash
Large area of liquid crystal display, clear and easy to understand
Receiver mini light, flash power supply, without battery
50 meters above the maximum sync speed regulation range, 1/250 seconds
Supports two types of power display mode (5.0~10.0 or 1/1~1/128)
Easy to install and use the camera control in hot shoe on demand
Wireless adjusting flash settings:
The trigger set can wireless adjust the following settings: the flash power ratio, the on-or-off of the buzzer and the modeling lamp or the AF-assist beam, as well as the power-ratio display mode.
On the transmitter and the receiver, set the channel select switch to the same position and the Power Control Group Select Dial to the same grade.
Insert the receiver into the Wireless Control Port of the flash unit. Then power the flash on.
Adjust the flash settings on your transmitter.
Wireless triggering the flash:
On the transmitter and the receiver, set the Channel Select Switch to the same position.
Insert the receiver into the Wireless Control Port of the flash unit. Then power the flash on.
Press the Test Button to fire a flash. Alternatively, you can set the transmitter onto the camera's hot shoe and press the camera's shutter-release button to fire a flash.
Support flash:
Witstro series flashes, QT series flashes, Gemini GT & GS series studio flashes, DE series flashes, DP series flashes.
Support camera:
Canon, Nikon, Pentax, Olympus...